Juice Extractor Instructions

Thanks for renting a Juice Extractor with Green Gooding. Here are some instructions to help you make the best use of this equipment.

Precautions

• Always unplug unit from outlet when not in use, before putting on or removing parts and before cleaning.

• To protect against electrical shock, do not immerse the juice extractor motor housing in water or other liquids.

• When any appliance is used by or near children, supervise closely.

• Avoid contact with moving parts.

• Do not allow the power cord to come into contact with any hot surfaces, including stove, or to hang over table edge or counter.

• Before turning the motor on, always make sure juice extractor cover is properly positioned and securely in place. Do not open cover while the juice extractor is in operation.

• Switch to OFF position after each use and be sure the motor stops completely before disassembling.

• Do not put fingers or other objects into the juice extractor opening while it is in operation. If food becomes stuck in the opening, use food pusher or another piece of fruit or vegetable to push it down. Or turn the motor off and disassemble the unit to remove the remaining food.

• Not designed for outdoor use.

Assembly Instructions

Assembling the Juice Pitcher

1. Place the juice pitcher on a flat surface.

2. Insert the foam separator.

3. Put cover in place. Set pitcher aside.

Assembling the Juice Extractor

1. Place base on a clean, flat surface.

2. Insert filter bowl, positioning spout on right side, on top of motor housing.

3. Place foam management filter disk in filter bowl.

4. Place mesh filter basket firmly in place in the filter bowl.

5. Hold the juice extractor cover by the handle with the feed tube facing back and the hinge straight down over the hinge slot on the motor housing. Insert the hinge into the slot and lower into position.

6. Make sure the handle lock is in the "open" position. Press handle in with an upward motion to close.

7. Slide the food pusher down the feed tube by aligning the groove in the food pusher with the small indent on the inside of the top of the feed tube.

8. Place the pulp container in position by tilting opening slightly under the cover.

9. Place the assembled juice pitcher under the spout, with the handle facing forward.

10. Make sure the spout is in the open position. Never juice with the spout in the closed position

Operating Instructions

1. Make sure your juice extractor is properly assembled. (See Assembly Instructions.)

2. Plug the power cord into a 120V electrical outlet.

3. Make sure that the spout is in the open position.

4. Wash all selected fruits or vegetables.

5. While most fruits such as apples, pears, carrots, etc. will not need cutting, any fruit or vegetable with a diameter larger than 3 inches will need to be cut.

6. Set the dial to the desired speed. The blue LED light ring on the control dial will start to blink.

7. Press the button in the center of the control dial to start the juice extractor. The LED light ring will stop blinking and stay on.

8. Lift the food pusher out of the feed tube and drop your food into the feed tube. Push through by inserting the food pusher and pressing firmly.

9. The juice will flow into the juice pitcher and the pulp will accumulate in the pulp container.

10. When finished juicing, press the On/Off button to stop the motor. Turn the control dial to “0” to shut off the juice extractor.

11. Before removing the juice pitcher from under the spout, turn the spout to the closed position. This will prevent juice from dripping